Rear Wheel Bearing Hub Assembly for Jeep and Fiat

Mevotech MB25323 is a rear wheel bearing and hub assembly built for specific Jeep and Fiat applications. It features a Gen 3 bearing design, comes pre-greased, and uses a 4-bolt flange with 6 wheel studs for direct replacement service.

Key Features

• Rear wheel bearing and hub assembly
• Gen 3 bearing generation for modern hub service
• Pre-greased for ready-to-install service
• 4 flange bolt holes
• 6 wheel studs
• 84.0 outside diameter
• ABS sensor not included

Fitment Details

• Fits 2018-2022 Jeep Compass, Rear
• Fits 2015-2021 Jeep Renegade, Rear
• Fits 2016-2018 Fiat 500X, Rear

Product Overview

Mevotech MB25323 is a rear hub assembly for Jeep Compass, Jeep Renegade, and Fiat 500X models listed above. The pre-greased design helps simplify service, while the Gen 3 bearing construction and 6-stud hub layout support a direct-fit replacement for rear wheel bearing and hub repair. This part cross-references Timken HA590619 for the same application.

Common Repair Uses

• Wheel bearing noise from the rear hub area
• Excessive play or looseness at the rear wheel
• Hub wear on high-mileage Jeep Compass or Jeep Renegade models
• Rear wheel vibration related to hub assembly wear
• Service replacement for Fiat 500X rear hub failure

Installation Notes

Verify rear fitment, flange bolt pattern, and wheel stud count before installation. Because the ABS sensor is not included, transfer or source the sensor separately if your vehicle requires one. Confirm axle and brake component condition during hub replacement, and torque all fasteners to the vehicle manufacturer’s specifications.

Quality Assurance

Mevotech MB25323 is a cataloged replacement hub assembly with confirmed vehicle-specific fitment for the rear position on the listed Jeep and Fiat models. The part number MB25323 is also used in Mevotech Supreme listings for this application.