Brake Kit for Encore and Trax

The Dynamite Friction DFC Geospec Rotors with 5000 Advanced Brake Pads kit is built for 2018-2022 Buick Encore and 2018-2022 Chevrolet Trax applications at the front and rear. Part number 4514-45043 combines coated rotors, advanced friction pads, and brake hardware in one service kit for a direct brake refresh.

Key Features

• Fits 2018-2022 Buick Encore, front and rear
• Fits 2018-2022 Chevrolet Trax, front and rear
• DFC 5000 Advanced pads are post-cured for stable friction performance
• Scorched pad surface helps reduce initial break-in time
• Rubber-steel-rubber shims support quieter operation and reduced vibration
• GeoSpec coated rotors use a silver-gray finish that resists rust better than conventional paint or zinc coatings
• Rotors are dry processed and ready to install
• Non-directional rotor finish supports even pad bed-in and smoother stops
• Hardware kit uses PTFE coating, vulcanized rubber, and stainless steel

Product Details

Part number 4514-45043 is a complete brake service kit for Buick Encore and Chevrolet Trax models listed above. The DFC Geospec rotor design follows OEM-style G3000/G11H18 cast iron specifications and is machined to tight tolerances for durability and stability. The 5000 Advanced brake pads are formulated for consistent friction, while the included hardware is engineered to restore proper spring tension and caliper movement during brake service. This kit is a practical choice for drivers searching for a front and rear brake kit for 2018-2022 Buick Encore or 2018-2022 Chevrolet Trax with coated rotors and advanced pads.

Common Problems This Kit Can Address

• Brake noise from worn pads or fatigued hardware
• Uneven pad wear caused by corroded or weakened hardware
• Rust buildup on exposed rotor surfaces
• Longer stopping response from worn friction components
• Vibration or harshness during braking

Installation Notes

Verify rotor size, caliper configuration, and axle position before installation. Clean all mating surfaces, inspect caliper slides, and replace any damaged mounting components during service. The rotors are shipped dry and ready to install, so no oil removal step is required before brake assembly. For best results, follow the vehicle-specific brake service procedure and complete a proper pad bed-in after installation.

Quality Assurance

DFC states that each rotor is inspected for critical dimensions and balance, and every rotor is backed by a 12-month warranty against defects in material and workmanship. The pad and hardware components are produced to support OE-style fit, form, and function for the listed Encore and Trax applications. Part number 4514-45043 is built for repeatable service results on the specified vehicles.