Front Upper Control Arm Assembly

Delphi TC6045 is a front upper suspension control arm and ball joint assembly built for Chrysler 300, Dodge Challenger, and Dodge Charger applications. It combines OE-focused materials and dimensional control with an adjustable design for front-end alignment correction.

Key Features

• Pre-greased for initial service readiness
• Stamped steel control arm construction with black finish
• Natural rubber bushings included
• Bolt-in ball joint mounting with threaded stud type
• Adjustable design for alignment tuning
• Front upper position
• Standard replacement grade

OE-Style Engineering

Delphi TC6045 is engineered using dimensional and material analysis to support proper OE-to-aftermarket compatibility. Delphi subjects steering and suspension components to extreme temperature testing below -40 degrees C and above 120 degrees C, along with extended salt-spray exposure, to evaluate durability in demanding conditions. This front upper control arm assembly is a direct-fit style replacement for Chrysler 300, Dodge Challenger, and Dodge Charger front suspension service.

This part cross-references Mevotech Supreme CMS251166 and MOOG Chassis Products RK100112 for the same application.

Vehicle Fitment

• Fits 2019-2022 Chrysler 300, Front Upper
• Fits 2018-2022 Dodge Challenger, Front Upper
• Fits 2018-2022 Dodge Charger, Front Upper
• Fits 2009-2018 Chrysler 300, Front Upper; Adjustable Ball Joint; Caster Plus or Minus 1 Degree(s); Camber Plus or Minus 2 Degrees
• Fits 2009-2017 Dodge Challenger, Front Upper; Adjustable Ball Joint; Caster Plus or Minus 1 Degree(s); Camber Plus or Minus 2 Degrees
• Fits 2009-2017 Dodge Charger, Front Upper; Adjustable Ball Joint; Caster Plus or Minus 1 Degree(s); Camber Plus or Minus 2 Degrees

Common Repair Uses

• Replacing a worn or noisy front upper control arm
• Restoring steering response and suspension geometry
• Addressing looseness from deteriorated bushings or ball joint wear
• Correcting alignment settings on adjustable applications
• Servicing front suspension on Chrysler 300, Dodge Challenger, or Dodge Charger models

Installation Notes

Verify vehicle year, model, and front upper position before installation. Mounting hardware is not included, so reuse or source the required fasteners as needed. After installation, perform a professional wheel alignment, especially on 2009-2018 Chrysler 300 and 2009-2017 Dodge Challenger and Dodge Charger applications with adjustable ball joint settings.

Quality Assurance

Delphi applies OE-focused testing and material validation to its steering and suspension portfolio, including temperature cycling and salt-spray exposure, to support consistent fit and durability. TC6045 is a standard replacement suspension component built to meet the demands of everyday road use.