Delphi Inner Tie Rod End for Nissan Kicks

Delphi TA3594 is a straight inner steering tie rod end built for OE-style replacement performance. It is listed for 2018-2020 Nissan Kicks applications and uses a steel housing with a steel tie rod for durable steering linkage service.

Key Features

• Part number: TA3594
• Fits 2018-2020 Nissan Kicks, inner steering position
• Straight tie rod end design
• Pre-greased for initial service
• Steel housing and steel tie rod construction
• Standard replacement grade
• Mounting hardware included
• Male threaded ends with left-hand thread direction

OE-Style Steering Replacement

Delphi applies OE engineering knowledge to its aftermarket steering parts, with dimensional and material analysis used to support proper part matching. TA3594 is a non-adjustable inner tie rod end with a threaded stud design, built for the steering linkage on Nissan Kicks models from 2018 through 2020. This part cross-references Mevotech Supreme MS30754 for the same application.

Common Problems This Part Can Address

• Excessive steering play from a worn inner tie rod end
• Clunking or looseness in the steering linkage
• Uneven tire wear caused by steering component wear
• Imprecise steering response on Nissan Kicks models
• Replacement needs after inspection reveals joint wear or corrosion

Installation Notes and Tips

Confirm the inner steering position before ordering and match the left-hand thread direction to the original component. Because this is a straight, non-adjustable tie rod end, alignment should be checked after installation. Verify fitment against the vehicle’s steering setup for 2018-2020 Nissan Kicks applications before service begins.

Quality Assurance

Delphi subjects steering components to temperature extremes below -40 degrees C and above 120 degrees C, along with extended salt-spray exposure, to evaluate durability and corrosion resistance. The brand’s OE-focused testing and dimensional analysis support consistent replacement quality for Nissan Kicks steering service.